HYDRAULIC BODY ST-80-11
- Send to a friend
- Remove this product from my favorite's list.
- Add this product to my list of favorites.
HYDRAULIC BODY SERIES ST4 "
Select your engine for the hydraulic body in the box below.
HYDRAULIC BODY SERIES ST4 "
Select your engine for the hydraulic body in the box below.
For deep wells, suitable for pumping clean water with a sand content below 25 g / m3. Suitable for irrigation, filling tanks, pressure equipment, Installing a valve 40/50 each mts retenciónpor recommended. Gage height to prevent water hammer.
It is recommended to leave the pump suspended in sufficiently well separated from the background.
They must not run dry.
Installing a box eléctricode protection level probes are recommended to prevent dry running.
STRUCTURAL CHARACTERISTICS
• Suction and discharge, check valve, shirt, suction filter and shaft in stainless steel AISI 304.
• floating turbines and diffusers policarbonatoreforzado fiberglass.
• Motor Franklin stainless steel AISI 304 SS, Nema coupling type, encapsulated in a water bath, continuous operation, insulation class B, 2800 rpm, IP-58, 1500 N axial load up to 1 hp., 3000 N up to 3 hp. 6,000 N other powers, 1.5 mts. electric cable, outdoor condenser for single phase models.
• Power supply: 1 x 230 v, v 3 x 230, 3 x 400 v...
FIELD OF WORK
• no aggressive clean water with the construction materials.
• Vertical and horizontal mounting.
• Maximum water depth: 350 mts.
• Maximum number of starts per hour: 20.
• Maximum water temperature: 30 ° C.
Under consultation phase pumps have 220 v.